Engineering and machinery
Job shop software for engineering and machining units
Job-based production against a drawing, with machine load to manage, operations sent out for plating or heat treatment, and a delivery date the customer will hold you to. FleekERP runs each job as a work order with its routing, tracks each machine's load by the hour and shows the operation that will make the job late.
Book a demoBook a demo for your plant
45 minutes, run on your own stages and quality checks.
What slows engineering and machining units down
- Late jobs show up lateYou find out a job will miss its date when the customer calls, not when the operation that caused it started running behind.
- Machines are overloaded or idleLoad is in the planner's head or a spreadsheet, so one machine has a queue while the next one waits for work.
- Job cost is a guessMachine hours, setup time and vendor charges are never added up per job, so the margin is known only roughly, if at all.
How it works
How your floor runs on FleekERP
- 1Enquiry to orderSales order with the drawing revision, quantity and delivery dateProduction control
- 2RoutingOperations, machines, rates and the vendor operations in sequenceProduction planning
- 3MaterialBar, plate and castings issued by heat number to the jobInventory and traceability
- 4MachiningCounts and downtime per machine, first-off and in-process checksShop floor apps
- 5Outsourced operationsChallan out, return in, short return flaggedSubcontracting control
- 6Inspection and dispatchFinal inspection, test report data, delivery note and invoiceQuality control
Built for engineering and machining units
- Drawing revision on the orderThe work order carries the drawing revision it was released against. A later revision does not change a running job.
- Machine load by the hourEach machine declares its capacity. The board shows load per day and the job that pushes it past 100.
- Job costing by operation hoursMachine hours from counts and setup, times the machine rate. Vendor cost from the challan. Margin per job.
Proof from other floors
Measured on real floors
None of our live customers are engineering and machining units yet. These factories are, and the same screens run your stages.
- Challenge
- OEM audit trails assembled from Excel, days per request
- Modules
- Production control, Traceability, Quality control
- Result
- Full lot trace in under 3 minutes. Excel traceability sheets gone.
- Challenge
- Planning took a full day; material over-consumption found after cutting
- Modules
- Production planning, Stock and BOM, Operator app
- Result
- Planning time down 60%. Over-consumption flagged while the roll is cut.
- Challenge
- Labour cost per order unknown; wages reconciled from bundle cards days later
- Modules
- Operator app, Production control, Cost per order
- Result
- Labour cost per order visible. Paper registers gone.
Cost and time
What it costs and how long it takes
- ₹199per employee login a month₹999 per user login, annual termSee pricing →
- ₹99,000one-time setup, up to 100 loginsSetup and training at the stationHow setup works →
- 18 daysto your first production line liveOn scope agreed before you startWhat's included →
Questions from engineering and machining units
We make to drawing, one-off and small batch. Does a routing per job work?
Yes. A routing is created per job, or copied from a similar one and edited. Operations, machines and vendor steps are in your words.
Can we track heat numbers on raw material?
Yes. Bar and plate are received by lot with the heat number, issued to the job, and traced forward to the delivery.
Next step
See FleekERP on your own production flow
Bring your routings and quality checks. We set them up before the call, so the demo shows your own stages.